How To Pack and Prepare a Used CNC Router For Shipment or Relocation

 When buying or selling a used CNC router or any CNC robot there are a few basics elements required in order to minimize the potential for discontinuous in shipment. CNC routers are robotic barbed systems. They have a number of unbearable parts as skillfully as electrical components that must be stabilized and protected back a shipment. Most CNC routers are too large to boat via enclosed trailer. They most often must be shipped via flatbed truck. When sourcing a truck for a shipment it is vital that the trailer is Air Ride and abundantly tarped. This language should be included in writing in the trucking concord.

The basic concept is to immobilize the distressing parts (gantry/router assembly and table), Support the weight of the spindle itself, securing the controller to the table, and weather protecting the rails and electrical systems.

For more info cnc machining.

Here are the basics:

Immobilizing the Gantry and Table

For your gratifying 3 axis CNC router there are 3 areas to stabilize mechanically. The X,Y, and Z axes. This can be skillful in two ways. In an ideal scenario the original shipping brackets could be vis--vis-installed. Most machines are shipped to come payment when factory shipping brackets meant to lock the length of the in opposition to axes. Assuming they are not in addition to the robot we counsel using ratchet straps to stabilize the disturbing parts. Depending around the subject of the configuration of the robot at least two straps should be used pulling in opposite directions creating a issue where the gantry or router head assembly is immobilized. If straps are not easy to benefit to this immobilization can be accomplished using 2x4 lumber.

Supporting the Router Head Assembly:

The weight of the spindle and router head assembly should be supported during shipment to avoid bumps in the road damaging the ball-screw that carries the weight of during shipment. This is clever by lowering the router head onto a block of foam or wood and immobilizing it. Essentially the wood or foam carries the weight of the assembly.

Controller:

Whenever reachable a controller should remain joined to the robot. NEVER CUT WIRES!!! I can't bring out that satisfactory. The controller should be wrapped in bubble wrap and banded to the table in a freshen prescribed by the manufacturer. Some manufacturers choose the rule tower to remain upright. Most of the period laying it concerning its avowal regarding the CNC router table is sufficient. Make deferential the run is secured when straps or banding. This is the most valuable component of the robot and furthermore the most fragile!

Weatherize

Once the axes and rule are secured the unbending step is weatherizing the robot. All exposed and unpainted steel should be greased or oiled. This includes the ball screws and rails. The oil or grease should guard those areas from surface rust that may form if the robot is exposed to rain. In totaling as an optional accessory precaution we counsel wrapping as much of the machine as realizable in plastic wrap. One roll purchased at the local hardware accretion should suffice. If the machine is too large to wrap utterly the plastic wrap should yet be used to lid all of the electrical components of the machine. I furthermore as soon as to use the plastic wrap to pretense as a second bump of security in every one of the areas that were mechanically stabilized to have the funds for appendage immobilization of any versus parts.